MPLS Commands
Page 242 7450 ESS MPLS Guide
transit-path
Syntax transit-path path-name
no transit-path
Context config>router>mpls>mpls-tp
Description This command enables the configuration or editing of an MPLS-TP transit path at an LSR.
Default no transit-path
Parameters path-name — Specifies the template of up to 32 characters in printable 7-bit ASCII, enclosed in
double quotes.
path-id
Syntax path-id {lsp-num lsp-num | working-path | protect-path [src-global-id src-global-id] src-
node-id src-node-id src-tunnel-num src-tunnel-num [dest-global-id dest-global-id] dest-
node-id dest-node-id [dest-tunnel-num dest-tunnel-num]}
no path-id
Context config>router>mpls>mpls-tp>transit-path
Description This command configures path ID for an MPLS-TP transit path at an LSR. The path ID is equivalent
to the MPLS-TP LSP ID and is used to generate the maintenance entity group intermediate point
(MIP) identifier for the LSP at the LSR. A path-id must be configured for on-demand OAM to verify
an LSP at the LSR.
The path-id must contain at least the following parameters: lsp-num, src-node-id, src-global-id, src-
tunnel-num, dest-node-id.
The path-id must be unique on a node. It is recommended that his is also configured to be a globally
unique value.
The no form of the command removes the path ID from the configuration.
Default no path-id
Parameters lsp-num — Specifues the LSP number.
Values 1 — 65535, or working path, or protect-path. A working-path is equivalent to a
lsp-num of 1, and a protect-path is an lsp-num of 2.
src-global-id — Specifies the source global ID.
Values 0 — 4294967295
src-node-id — Specifies the source node ID.
Values a.b.c.d or 1 — 4294967295
src-tunnel-num — Specifies the source tunnel number.
Values 1 — 61440
To Next Page
Loading...
