MPLS and RSVP
7450 ESS MPLS Guide Page 247
adjust-down
Syntax adjust-down percent [bw mbps]
no adjust-down
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the minimum threshold for decreasing the bandwidth of an LSP based on
active measurement of LSP bandwidth.
The no form of this command is equivalent to adjust-down 5.
Default no adjust-down
Parameters percent — Specifies the minimum difference between the current bandwidth reservation of the LSP
and the (measured) maximum average data rate, expressed as a percentage of the current
bandwidth, for decreasing the bandwidth of the LSP.
Values 1 — 100
Default 5
mbps — Specifies the minimum difference between the current bandwidth reservation of the LSP and
the (measured) maximum average data rate, expressed as an absolute bandwidth (mbps), for
decreasing the bandwidth of the LSP.
Values 0 — 100000
Default 0
adjust-up
Syntax adjust-up percent [bw mbps]
no adjust-up
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the minimum threshold for increasing the bandwidth of an LSP based on
active measurement of LSP bandwidth.
The no form of this command is equivalent to adjust-up 5.
Default no adjust-up
Parameters percent — Specifies the minimum difference between the current bandwidth reservation of the LSP
and the (measured) maximum average data rate, expressed as a percentage of the current
bandwidth, for increasing the bandwidth of the LSP.
Values 1-100
Default 5
To Next Page
Loading...
