MPLS Commands
Page 248 7450 ESS MPLS Guide
mbps — Specifies the minimum difference between the current bandwidth reservation of the LSP and
the (measured) maximum average data rate, expressed as an absolute bandwidth (mbps), for
increasing the bandwidth of the LSP
Values 0 — 100000
Default 0
fc
Syntax fc fc-name sampling-weight sampling-weight
no fc
Context config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the sampling weight.
max-bandwidth
Syntax max-bandwidth mbps
no max-bandwidth
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the maximum bandwidth that auto-bandwidth allocation is allowed to
request for an LSP.
The LSP maximum applies whether the bandwidth adjustment is triggered by normal adjust-interval
expiry, the overflow limit having been reached, or manual request.
The no form of the command means max-bandwidth is 100 Gbps.
The max-bandwidth must be greater than the min-bandwidth.
Default no max-bandwidth
Parameters mbps — Specifies the maximum bandwidth in mbps.
Values 0 — 100000
Default 0
To Next Page
Loading...
