MPLS and RSVP
7450 ESS MPLS Guide Page 249
min-bandwidth
Syntax min-bandwidth mbps
no min-bandwidth
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the minimum bandwidth that auto-bandwidth allocation is allowed to
request for an LSP.
The LSP minimum applies whether the bandwidth adjustment is triggered by normal adjust-timer
expiry or manual request.
The no form of the command means min-bandwidth is zero.
Default no min-bandwidth
Parameters mbps — Specifies the minimum bandwidth in mbps.
Values 0 — 100000
Default 0
monitor-bandwidth
Syntax [no] monitor-bandwidth
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command enables the collection and display of auto-bandwidth measurements, but prevents any
automatic bandwidth adjustments from taking place.
This command is mutually exclusive with the overflow-limit command.
The no form of the command the collection and display of auto-bandwidth measurements.
multipliers
Syntax multipliers sample-multiplier num1 adjust-multiplier num2
no multipliers
Context config>router>mpls>lsp>auto-bandwidth
config>router>mpls>lsp-template>auto-bandwidth
Description This command configures the sample-multiplier and adjust-multiplier applicable to one particular
LSP.
The sample-multiplier configures the number of collection intervals between measurements of the
number of bytes that have been transmitted on the LSP. The byte counts include the layer 2
encapsulation of MPLS packets and represent traffic of all forwarding classes and priorities (in-
profile vs, out-of-profile) belonging to the LSP. The router calculates the average data rate in each
To Next Page
Loading...
