Alcatel-Lucent 7450 - Page 317

MPLS and RSVP
7450 ESS MPLS Guide Page 317
*A:SRU4>config>router>mpls# show router mpls label-range
===============================================================================
Label Ranges
===============================================================================
Label Type Start Label End Label Aging Total Available
-------------------------------------------------------------------------------
Static-lsp 32 1023 - 736
Static-svc 2048 18431 - 16384
Dynamic 32768 131071 258 93232
===============================================================================
*A:SRU4>config>router>mpls#
lsp
Syntax lsp lsp-name [status {up|down}] [from ip-address | to ip-address] [detail]
lsp {transit | terminate} [status {up | down}] [from ip-address | to ip-address | lsp-name
name] [detail]
lsp count
lsp lsp-name activepath
lsp lsp-name path [path-name] [status {up |down}] [detail]
lsp [lsp-name] path [path-name] mbb
Context show>router>mpls
Description This command displays LSP details.
Parameters lsp lsp-name — The name of the LSP used in the path.
status up — Displays an LSP that is operationally up.
status down — Displays an LSP that is operationally down.
from ip-address — Displays the IP address of the ingress router for the LSP.
to ip-address — Displays the IP address of the egress router for the LSP.
transit — Displays the number of static LSPs that transit through the router.
terminate — Displays the number of static LSPs that terminate at the router.
lsp count — Displays the total number of LSPs.
activepath — Displays the present path being used to forward traffic.
mbb — Displays make-before-break (MBB) information.
detail — Displays detailed information.
Output MPLS LSP Output — The following table describes MPLS LSP output fields.
Total Available
The number of label values available.
Label Description
Label Description
LSP Name
The name of the LSP used in the path.