Page 318 7450 ESS MPLS Guide
To
The system IP address of the egress router for the LSP.
Adm State
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Oper State
Down — The path is operationally down.
Up — The path is operationally up.
Oper State
Down — The path is operationally down.
Up — The path is operationally up.
LSPs
The total number of LSPs configured.
From
The IP address of the ingress router for the LSP.
LSP Up Time
The length of time the LSP has been operational.
Transitions
The number of transitions that have occurred for the LSP.
Retry Limit
The number of attempts that the software should make to re-establish
the LSP after it has failed.
Signaling
Specifies the signaling style.
Hop Limit
The maximum number of hops that an LSP can traverse, including the
ingress and egress routers.
Fast Reroute/
FastFail Config
enabled — Fast reroute is enabled. In the event of a failure, traffic
is immediately rerouted on the pre-computed detour LSP, thus mini-
mizing packet loss.
disabled — There is no detour LSP from each node on the primary
path.
ADSPEC
enabled — The LSP will include advertising data (ADSPEC)
objects in RSVP messages.
disabled — The LSP will not include advertising data (ADSPEC)
objects in RSVP messages.
Primary
The preferred path for the LSP.
Secondary
The alternate path that the LSP will use if the primary path is not avail-
able.
Bandwidth
The amount of bandwidth in megabits per second (Mbps) reserved for
the LSP path.
LSP Up Time
The total time in increments that the LSP path has been operational.
LSP Tunnel ID
The value which identifies the label switched path that is signaled for
this entry.
Label Description (Continued)
To Next Page
Loading...
