EasyManua.ls Logo

Alcatel-Lucent 7450 - Page 319

Alcatel-Lucent 7450
816 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MPLS and RSVP
7450 ESS MPLS Guide Page 319
To
The IP address of the egress router for the LSP.
LSP Down Time
The total time in increments that the LSP path has not been opera-
tional.
Path Changes
The number of path changes this LSP has had. For every path change
(path down, path up, path change), a corresponding syslog/trap (if
enabled) is generated.
Retry Timer
The time, in seconds, for LSP re-establishment attempts after an LSP
failure.
Resv Style
se — Specifies a shared reservation environment with a limited res-
ervation scope. This reservation style creates a single reservation over
a link that is shared by an explicit list of senders.
ff — Specifies a shared reservation environment with an explicit
reservation scope. Specifies an explicit list of senders and a distinct
reservation for each of them.
Negotiated MTU
The size of the maximum transmission unit (MTU) that is negotiated
during establishment of the LSP.
FR Hop Limit
The total number of hops a detour LSP can take before merging back
onto the main LSP path.
LastResignalAt-
tempt
Displays the system up time when the last attempt to resignal this LSP
was made.
MBB Type
Displays an enumerated integer that specifies the type of make-before-
break (MBB). If none displays then there is no MBB in progress or no
last MBB.
MBB State
Displays the state of the most recent invocation of the make-before-
break functionality.
End at
Displays the system up time when the last MBB ended.
Old Metric
Displays the cost of the traffic engineered path for the LSP path prior
to MBB.
NextRetryIn
Displays the amount of time remaining, in seconds, before the next
attempt is made to retry the in-progress MBB.
RetryAttempt
Displays the number attempts for the MBB is in progress.
Failure Code
Displays the reason code for in-progress MBB failure. A value of none
indicates that no failure has occurred.
Failure Node
Displays the IP address of the node in the LSP path at which the in-
progress MBB failed. When no failure has occurred, this value is none.
Label Description (Continued)

Table of Contents

Other manuals for Alcatel-Lucent 7450

Related product manuals