Alcatel-Lucent 7450 - Page 331

MPLS and RSVP
7450 ESS MPLS Guide Page 331
*A:SRU4>config>router>mpls# show router mpls lsp detail
===============================================================================
MPLS LSPs (Originating) (Detail)
===============================================================================
-------------------------------------------------------------------------------
Type : Originating
-------------------------------------------------------------------------------
LSP Name : to_110_20_1_1_cspf
LSP Type : RegularLsp LSP Tunnel ID : 1
From : 110.20.1.4
Adm State : Up Oper State : Up
LSP Up Time : 0d 01:47:49 LSP Down Time : 0d 00:00:00
Transitions : 11 Path Changes : 11
Retry Limit : 0 Retry Timer : 30 sec
Signaling : RSVP Resv. Style : SE
Hop Limit : 255 Negotiated MTU : 1500
Adaptive : Enabled ClassType : 0
FastReroute : Disabled Oper FR : Disabled
CSPF : Enabled ADSPEC : Disabled
Metric : 0 Use TE metric : Disabled
Include Grps: Exclude Grps :
None None
Least Fill : Disabled
LdpOverRsvp : Enabled VprnAutoBind : Enabled
IGP Shortcut: Enabled
Oper Metric : 1001
Primary(a) : to_110_20_1_1 Up Time : 0d 01:47:49
Bandwidth : 0 Mbps
-------------------------------------------------------------------------------
...
-------------------------------------------------------------------------------
Type : Originating
-------------------------------------------------------------------------------
LSP Name : to_10_100_1_1_cspf_20
LSP Type : RegularLsp LSP Tunnel ID : 201
From : 110.20.1.4
Adm State : Up Oper State : Down
AB Max AvgR*
The maximum average data rate in any sample interval of the current
adjust interval.
AB Lst AvgR*
The average data rate measured in the sample interval that ended
most recently.
AB Ovfl Lmt
The configured value of the auto-bandwidth overflow-limit.
AB Ovfl Cnt
The number of overflow samples since the last reset.
ABOvflThres
The percent threshold for declaring an overflow sample.
AB Ovfl BW
The absolute bandwidth threshold for declaring an overflow sample
(in Mbps).
AB Monitor BW
True – monitor bandwidth is enabled on the LSP.
False – monitor bandwidth is not enabled on the LSP.
Label Description (Continued)