MPLS and RSVP
7450 ESS MPLS Guide Page 363
Least Fill : Disabled
Auto BW : Disabled
LdpOverRsvp : Enabled VprnAutoBind : Enabled
IGP Shortcut: Enabled BGP Shortcut : Enabled
IGP LFA : Disabled IGP Rel Metric : Disabled
BGPTransTun : Enabled
Oper Metric : Disabled
Prop Adm Grp: Disabled
P2MPInstance: 1 P2MP-Inst-type : Primary
S2L Cfg Cou*: 4 S2L Oper Count*: 4
S2l-Name : path_ipmsi To : 10.20.1.1
S2l-Name : path_ipmsi To : 10.20.1.2
S2l-Name : path_ipmsi To : 10.20.1.5
S2l-Name : path_ipmsi To : 10.20.1.6
=======================================================================
srlg-database
Syntax srlg-database [router-id ip-address] [interface ip-address]
Context show>router>mpls
Description This command displays MPLS SRLG database information.
Parameters router-id ip-address — Specifies a 32-bit integer uniquely identifying the router in the Autonomous
System. By convention to ensure uniqueness, this may default to the value of one of the router's
IPv4 host addresses, represented as a 32-bit unsigned integer, if IPv4 is configured on the router.
The router-id can be either the local one or some remote router.
interface ip-address — Specifies the IP address of the interface.
To Next Page
Loading...
