Alcatel-Lucent 7450 - Page 364

Page 364 7450 ESS MPLS Guide
path
Syntax path [path-name] [lsp-binding]
Context show>router>mpls
Description This command displays MPLS paths.
Parameters path-name — The unique name label for the LSP path.
lsp-binding — Keyword to display binding information.
Output MPLS Path Output — The following table describes MPLS Path output fields.
Sample Output
*A:SRU4>config>router>mpls# show router mpls path
===============================================================================
MPLS Path:
===============================================================================
Path Name Adm Hop Index IP Address Strict/Loose
-------------------------------------------------------------------------------
to_110_20_1_1 Up no hops n/a n/a
to_110_20_1_2 Up no hops n/a n/a
to_110_20_1_3 Up no hops n/a n/a
to_110_20_1_4 Up no hops n/a n/a
to_110_20_1_5 Up no hops n/a n/a
Label Description
Path Name
The unique name label for the LSP path.
Adm
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Hop Index
The value used to order the hops in a path.
IP Address
The IP address of the hop that the LSP should traverse on the way to
the egress router.
Strict/Loose
Strict — The LSP must take a direct path from the previous hop
router to the next router.
Loose — The route taken by the LSP from the previous hop to the
next hop can traverse through other routers.
LSP Name
The name of the LSP used in the path.
Binding
Primary — The preferred path for the LSP.
Secondary — The standby path for the LSP.
Paths
Total number of paths configured.