Page 400 7450 ESS MPLS Guide
cspf
Syntax cspf to ip-address
Context tools>perform>router>mpls
Sample Output
*A:Dut-C# /tools perform router mpls cspf to 10.20.1.6
Req CSPF for all ECMP paths
from: this node to: 10.20.1.6 w/(no Diffserv) class: 0 , setup Priority 7, Hold
Priority 0 TE Class: 7
CSPF Path
To : 10.20.1.6
Path 1 : (cost 2000)
Src: 10.20.1.3 (= Rtr)
Egr: unnumbered lnkId 4 -> Ingr: unnumbered lnkId 2
Rtr: 10.20.1.5 (met 1000)
Egr: unnumbered lnkId 3 -> Ingr: unnumbered lnkId 3
Rtr: 10.20.1.6 (met 1000)
Dst: 10.20.1.6 (= Rtr)
Path 2 : (cost 2000)
Src: 10.20.1.3 (= Rtr)
Egr: unnumbered lnkId 5 -> Ingr: unnumbered lnkId 5
Rtr: 10.20.1.4 (met 1000)
Egr: unnumbered lnkId 3 -> Ingr: unnumbered lnkId 2
Rtr: 10.20.1.6 (met 1000)
Dst: 10.20.1.6 (= Rtr)
*A:Dut-C#
force-switch-path
Syntax force-switch-path [lsp lsp-name] [path path-name]
Context tools>perform>router>mpls
Description
Use this command to move from a standby path to any other standby path regardless of
priority.
The no form of the command reverts to priority path.
Parameters
lsp-name — Specifies an existing LSP name to move.
path-name — Specifies the path name to which to move the specified LSP.
To Next Page
Loading...
