Page 402 7450 ESS MPLS Guide
[excl-node-id..(up to 8 max)]] [skip-interface interface-name] [ds-class-type class-type]
[cspf-reqtype req-type] [least-fill-min-thd thd] [setup-priority val] [hold-priority val]
Context tools>perform>router>mpls
Description This command computes a CSPF path with specified user constraints.
Default none
Parameters to ip-addr — Specify the destination IP address.
from ip-addr — Specify the originating IP address.
bandwidth bandwidth — Specifies the amount of bandwidth in mega-bits per second (Mbps) to be
reserved.
include-bitmap bitmap — Specifies to include a bit-map that specifies a list of admin groups that
should be included during setup.
exclude-bitmap bitmap — Specifies to exclude a bit-map that specifies a list of admin groups that
should be included during setup.
hop-limit limit — Specifies the total number of hops a detour LSP can take before merging back onto
the main LSP path.
exclude-address ip-addr — Specifies IP addresses, up to 8, that should be included during setup.
use-te-metric — Specifies the use of the traffic engineering metric used on the interface.
strict-srlg — Specifies whether to associate the LSP with a bypass or signal a detour if a bypass or
detour satisfies all other constraints except the SRLG constraints.
srlg-group grp-id — Specifies up to 8 Shared Risk Loss Groups (SRLGs). An SRLG group
represents a set of interfaces which could be subject to the same failures or defects and thus share
the same risk of failing.
Values 0 — 4294967295
exclude-node excl-node-id — specifies a list of address that should be excluded when this LSP is
setup.
skip-interface interface-name — Specifies an interface name that should be skipped during setup.
ds-class-type class-type
— Specifies the class type (CT) associated with this LSP.
Values 0 — 7
cspf-reqtype req-type — Specifies the req. type.
Values all, random, least-fill
least-fill-min-thd thd — Specifies whether the use of the least-fill path selection method for the
computation of the path of this LSP is enabled.
Values 1 — 100
setup-priority val — Specifies the setup priority to use when insufficient bandwidth is available to
setup an LSP.
Values 0 — 7
To Next Page
Loading...
