Page 490 7450 ESS MPLS Guide
Parameters peer-node-id — Specifies the control plane node ID of the neighboring GMPLS UNI-N node. This
can be an IP address or a 32-bit unsigned integer.
Values {a.b.c.d | 1 — 4294967295}
detail — Keyword to request more detailed output.
statistics — Keyword to request peer statistics.
path
Syntax path [path-name]
Context show>router>gmpls
Description This command displays GMPLS path information.
Parameters path-name — Specifies a unique case-sensitive name label for the LSP path.
Values 32 characters maximum alphanumeric string
session
Syntax session [session-type] [from ip-address] [to ip-address] [session-name session-name]
[status {up | down}] [detail]
Context show>router>gmpls
Description This command displays GMPLS session information.
Parameters session-type — Keyword to display information about the session type.
from ip-address — Specifies the system IP address of the near-end UNI-C router.
to ip-address — Specifies the system IP address of the far-end UNI-C router.
session-name — Specifies the name of the GMPLS session.
status — Specifies that the command display only GMPLS sessions that are either operationally up
or down.
Values up — Display only sessions that are operationally up.
down — Display only sessions that are operationally down.
detail — Keyword to request more detailed output.
te-link
Syntax te-link [te-link-id]
Context show>router>gmpls
Description This command displays Traffic Engineering (TE) link information.
To Next Page
Loading...
