Copyright @ALE 2020 All Rights Reserved
Restart the desk phone (unplug and plug in the power jack if you are using an external
power adapter or the Ethernet connector – LAN).
8.2.3 Changing or updating the paper label
Remove the protective cover (1): insert a thin object (or your fingernail) in the slot (a) to lift
the protective cover. Slide the cover down. The cover is held in place by small notches,
take care not to break the plastic cover near the notches.
Remove the cover from the other notches (c, d) by moving the cover gently from right to
left.
Remove the paper label with a thin object.
Replace the paper label and protective cover (2):
the cover or the paper can only be placed in the right way. Insert the paper label under the
first notches (a). Then, insert the other notches by sliding the paper up (b, c, d). If necessary,
you can gently press the paper near the notch to help it to slide under the notch.
Put the protective cover back in the same way.
8.2.4 Configure Add-on keys
EM20 and EM200’s programmble keys have the same function defined in Chapter 5.6. following
the same process , end user can set the related type.
8.3 EGO Personal conference module
The EGO Personal conference module is a compact and portable conference module. It provides
OmniSound® audio technology for very high-quality HD audio conversations. In addition, the EGO
comes with a 1000m Ah Li-ion battery for up to 12 hours of meetings and calls. The EGO can be
connected to your desk phone, mobile phone, tablet and computer. This section describes how to
use the conference module with your desk phone. To use the EGO with your computer, mobile
phone, or tablet, or for more information about the device, see the complete user manual of the
device (8AL90358xxAA).
To Next Page
Loading...
Need help?
General
