Allen-Bradley PowerFlex 40 User Manual

116 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 11 Add Distributed I/O Modules to the Project
7. Choose Disable Keying.
8. Uncheck the Open Module
Properties checkbox and click
OK.
The adapter is added to the
I/O configuration.
9. Right-click the 1734 POINT
network adapter module and
select New Module.
4. Type a name for the
adapter.
5. For an EtherNet/IP
network, type the IP
address.
For a ControlNet
network, enter the
adapter’s node
number.
Use the Network
Worksheet located
inside the back cover
as a reference.
6. Select the Chassis
Size (exact number
of POINT I/O
modules + 1 for the
adapter).
EtherNet/IP
ControlNet
EtherNet/IP
ControlNet

Allen-Bradley PowerFlex 40 Specifications

General

Output Voltage	0 to Input Voltage
Enclosure	IP20
Control Method	V/Hz, Sensorless Vector Control
Communication	RS485
Frequency	0 to 400 Hz
Protection	Overload, Overvoltage, Undervoltage, Short Circuit
Operating Temperature	-10 to 50°C (14 to 122°F)
Storage Temperature	-40...70 °C (-40...158 °F)
Humidity	5% to 95% non-condensing
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC (depending on model)