Allen-Bradley PowerFlex 40 User Manual

87Publication IASIMP-QS001C-EN-P - October 2009 87
Chapter 8
Configure the ControlNet Driver
In this chapter, you configure the ControlNet driver for your computer so you can program
over a ControlNet network.
Before You Begin
• Prepare the computer, see Chapter 2.
• Install all hardware, see Chapters 1-6
.
• Connect the computer, controller and all other ControlNet devices to a ControlNet
network. This example uses BNC coaxial connectors to connect the taps and a
terminating resistor at each end.
• Verify that power is applied to all devices.
What You Need
• RSNetWorx for ControlNet
• A 1784-PCIC or 1784-PCICS card and associated driver installed on your computer
Follow These Steps
If you have a ControlNet network, complete this step.
Configure the
ControlNet Driver in
RSLinx
page 88

Allen-Bradley PowerFlex 40 Specifications

General

Output Voltage	0 to Input Voltage
Enclosure	IP20
Control Method	V/Hz, Sensorless Vector Control
Communication	RS485
Frequency	0 to 400 Hz
Protection	Overload, Overvoltage, Undervoltage, Short Circuit
Operating Temperature	-10 to 50°C (14 to 122°F)
Storage Temperature	-40...70 °C (-40...158 °F)
Humidity	5% to 95% non-condensing
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC (depending on model)