Allen-Bradley PowerFlex 40 User Manual

68 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 5 Prepare the PowerFlex 40 Drive
0.5-0.6 N-m
(4-5 lb.-in.)
4. Place the adapter cover on the PowerFlex.
5. Tighten the screws.
6. For all networks, connect the network cable to the
adapter.
7. Apply power to the PowerFlex 40 drive.
Important: The front side of the ControlNet adapter faces down
when it is installed in the drive. So, in the installed position, port
A is to the right of port B.
3. Snap the adapter into the cover and connect the cable from the adapter to the
PowerFlex 40 drive.
0.5…0.6 Nm
(4…5 lb-in)

Allen-Bradley PowerFlex 40 Specifications

General

Output Voltage	0 to Input Voltage
Enclosure	IP20
Control Method	V/Hz, Sensorless Vector Control
Communication	RS485
Frequency	0 to 400 Hz
Protection	Overload, Overvoltage, Undervoltage, Short Circuit
Operating Temperature	-10 to 50°C (14 to 122°F)
Storage Temperature	-40...70 °C (-40...158 °F)
Humidity	5% to 95% non-condensing
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC (depending on model)