Allen-Bradley PowerFlex 40 User Manual

78 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 6 Prepare the PanelView Plus Terminal
5. Select IP Address [F1].
a. Enter an IP address in
the input panel.
b. Press Enter.
c. Record IP address in
Appendix A.
For information on IP
addresses, see
Chapter 7.
6. Select Subnet Mask [F2].
a. Enter the subnet mask
you wrote on the
Network
Worksheet.
b. Press Enter.
7. Select OK [F7] to save
settings, then OK [F7]
again to acknowledge
reset message.

Allen-Bradley PowerFlex 40 Specifications

General

Output Voltage	0 to Input Voltage
Enclosure	IP20
Control Method	V/Hz, Sensorless Vector Control
Communication	RS485
Frequency	0 to 400 Hz
Protection	Overload, Overvoltage, Undervoltage, Short Circuit
Operating Temperature	-10 to 50°C (14 to 122°F)
Storage Temperature	-40...70 °C (-40...158 °F)
Humidity	5% to 95% non-condensing
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC (depending on model)