ZA-V BAG0087.11
Adjust the spreading vanes as follows:
1. Switch off the tractor PTO shaft.
2. Secure the tractor against unintentional starting and unintention-
al rolling away.
3. Wait until any rotating spreading discs have come to a full stop.
4. Adjust the desired working width on both spreading discs by
swivelling the short and long spreading vane.
4.1 Turn the spreading disc in such a manner that each sprea
ing vane can be easily adjusted.
4.2 Obtain the required setting values for the short and long
spreading vane from the setting chart.
4.3 Press the hand lever down and adjust the spreading vane
in such a manner that the vane locking mechanism indi-
cates the required setting value on the scale.
4.4
Release the hand lever so that the vane locking mechanism
secures the set position.
8.7 Checking the working width and lateral distribution
The working width is influenced by the respective spreading proper-
ties of the fertiliser.
The most important influential factors on the spreading properties are
known to be
• the grain size,
• the bulk density,
• the surface properties and
• the moisture.
The setting values from the setting chart are therefore only to be con-
sidered as reference values, since the spreading properties of the
fertiliser types can change.
Check the working width and lateral distribution and optimise the
fertiliser spreader settings by using:
• a mobile test rig
• EasyCheck
→ See separate operating manual
To Next Page
Loading...
Need help?
General