-V BAG0087.11 01.20
9 Transportation
• Comply with the chapter "Safety information for the user", from
page 25 when moving.
• Before moving off, check:
ο The correct connection of the supply lines
ο The lighting system for damage, function and cleanliness
ο The hydraulic system for visible defects
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
through unintentional releasing of the coupled machine!
Carry out a visual check that the upper and lower link pins are firmly
secured against unintentional release.
WARNING
Risk of contusions, cuts, dragging, catching or knocks from
tipping and insufficient stability.
• Drive in such a way that you always have full control over the
tractor with the attached machine.
In so doing, take your personal abilities into account, as well as
the road, traffic, visibility and weather conditions, the driving
characteristics of the tractor and the connected machine.
• Before transportation, fasten the side locking of the tractor lower
link, so that the connected or coupled machine cannot swing
back and forth.
WARNING
Danger of breaking during operation, insufficient stability and
insufficient tractor steering and braking power on improper use
of the tractor!
Comply with the maximum load of the connected machine and the
approved axle and support loads of the tractor. If necessary, drive
only with a partially filled hopper.
WARNING
Risk of falling from the machine if riding against regulations!
It is forbidden to ride on the machine and/or climb the running ma-
chine.
• During road transport, only lift the centrifugal broadcaster until
the top edge of the reflector is no more than 1500
road surface.
• Secure the machine against unintentiona
l lowering before driving
on the road!
• Fold up the hopper access ladder before driving on roads.
To Next Page
Loading...
Need help?
General