Cleaning, maintenance and repairs
-V BAG0087.11 01.20
12.1 Cleaning
• Pay particular attention to the brake, air and hydraulic hose
lines.
• Never treat brake, air and hydraulic hose lines with benzene,
benzole, petroleum or mineral oils.
• After cleaning, grease the machine, in particular after cleaning
with a high pressure cleaner / steam jet or liposoluble agents.
• Observe the statutory requirement for the handling and removal
of cleaning agents.
Cleaning with a high pressure cleaner / steam jet
• Always observe the following points when using a high pressure
cleaner / steam jet for cleaning:
ο Do not clean any electrical components.
ο Do not clean any chromed components.
ο Never aim the cleaning jet of the cleaning nozzle of the
high pressure cleaner/steam jet directly at lubrication
points, bearings, rating plates, warning signs, and stickers.
ο Always maintain a minimum jet distance of 300mm be-
tween the high pressure cleaning or steam jet cleaning
nozzle and the machine.
ο The set pressure of the high-pressure cleaner / steam jet
must not exceed 120 bar.
ο Comply with safety regulations when working with high
pressure cleaners.
• Clean machine with regular water jet (oiled implements only at
washbays with oil separators).
• Give particular attention to cleaning discharge openings and
sliders.
• Remove fertiliser deposits from the spreading discs and the
spreading vanes.
• When the machine is dry, apply a coat of anti-rust compound.
(Use only biodegradable compounds).
Always install the central bolt for the spreading disc as protection
from water, even if the spreading discs are not installed.
• Clean the spreading discs very carefully and protect from corro-
sion.
Stainless steel components can also corrode when they come
into contact with the spreading material, however, this does not affect
their function.
To Next Page
Loading...
Need help?
General