-V BAG0087.11 01.20
11.4 Faults, causes and remedies
Fertiliser lateral distribution not
uniform
Fertiliser deposits on the spread-
ing discs and the spreading
vanes.
Clean the spreading discs and
the spreading vanes.
Sliders do not open all the way.
Too much fertiliser in the tractor
track
Prescribed spreading disc speed
is not reached.
Increase tractor engine speed.
Spreading vanes and outlets
defective or worn.
Check the spreading vanes and
outlets. Replaced defective or
worn parts immediately.
The spreading properties of your
fertiliser differ from those of the
one we tested when creating the
setting chart.
AMAZONE Fertiliser Service.
+49 5405 501-111
Too much fertiliser in the overlap
area
Prescribed spreading disc speed
is exceeded.
Reduce tractor engine speed.
The spreading properties of your
fertiliser differ from those of the
one we tested when creating the
setting chart.
AMAZONE Fertiliser Service.
+49 5405 501 - 111
Both hopper tips do not empty
uniformly at the identical slider
position
Eliminate cause of bridging.
R-clip in the spiral agitator has
shorn off due to overloading.
Basic settings of the sliders differ
Check basic settings of the slid-
ers.
Overheating of the tractor hy-
draulic fluid
System converting bolt on the
hydraulic block is incorrectly set
Fluid quantity not reduced
enough on the tractor control
unit.
Adjust the system converting bolt
correctly on the hydraulic block
Reduce the fluid quantity on the
tractor control unit.