ZA-V BAG0087.11
5.8.2 Uncoupling the PTO shaft
WARNING
Danger from crushing or impact if there is insufficient clearance
when uncoupling the PTO shaft!
First uncouple the machine from the tractor before uncoupling the
PTO shaft from the tractor. This will ensure the necessary clearance
for safe uncoupling of the PTO shaft.
WARNING
Danger from burns on hot components of the PTO shaft!
Do not touch components of the PTO shaft that have become hot
(particularly clutches).
• After decoupling the PTO shaft, place it on the holder provided.
This protects the PTO shaft from damage and dirt.
• Clean and lubricate the universal joint shaft if it will not be used
for an extended period.
1. Uncouple the machine from the tractor. Also
refer to the chapter "Uncoupling the ma-
chine", page 86.
2. Drive the tractor up to the machine, leaving
a clearance of approximately 25 cm be-
tween the tractor and the machine.
3. Secure the tractor against unintentional
starting and rolling away, see the chapter
"Securing the tractor against unintentional
starting and rolling away", from page 80.
4. Pull the latch of the PTO shaft off the uni-
versal joint shaft of the tractor. Observe the
operating manual supplied with the PTO
shaft when uncoupling the PTO shaft.
5. Place the PTO shaft in the holder provided
(Fig. 19).
6. Clean and lubricate the universal joint shaft
if it is not going to be used for a longer peri-
od of time.
20
To Next Page
Loading...
Need help?
General