Amazone EasySet 2 User Manual

Structure and function
ZA
-V BAG0087.11 01.20
55
Identification of the fertiliser
Representation of the ferti-
liser
Name of the fertiliser
Grain diameter
Bulk density
Calibration fac-
tor
The calibration factor is used as a default
value for fertiliser calibration.
If you cannot definitively assign the fertiliser to a kind listed in the
setting chart
• the AMAZONE Fertiliser Service will assist you over the tele-
phone in assigning the fertilisers and setting recommendations.
 +49 (0) 54 05 / 501 111
• please consult the contact partner in your country
Boundary spreading:
• ZA-V Hydro. Refer to the separate page in the setting chart.
(The fertiliser-specific pages of the setting chart show the set-
tings for boundary spreading with limiter.)
• The fertiliser-specific setting charts "Shutter position for rate
setting" are only intended to set the rate on implements without
a control terminal

Amazone EasySet 2 Specifications

General

Brand	Amazone
Model	EasySet 2
Category	Spreader
Language	English