User Manual – Rev BE AMETEK Programmable Power
MX Series 5
Important Safety Instructions
Hazardous voltages may be present when covers are removed. Qualified personnel
must use extreme caution when servicing this equipment. Circuit boards, test
points, and output voltages also may be floating above (below) chassis ground.
Before applying power to the system, verify that your product is configured properly
for your application.
In normal operation, the operator does not have access to hazardous voltages within
the chassis. However, depending on the user’s application configuration, HIGH
VOLTAGES HAZARDOUS TO HUMAN SAFETY may be normally generated on the
output terminals. The customer/user must ensure that the output power lines are
labeled properly as to the safety hazards and that any inadvertent contact with
hazardous voltages is eliminated.
Guard against risks of electrical shock during open cover checks by not touching any
portion of the electrical circuits. Even when power is off, capacitors may retain an
electrical charge. Use safety glasses during open cover checks to avoid personal
injury by any sudden component failure.
Neither AMETEK Programmable Power Inc., San Diego, California, USA, nor any of
the subsidiary sales organizations can accept any responsibility for personnel,
material or inconsequential injury, loss or damage that results from improper use of
the equipment and accessories.
To Next Page
Loading...
Need help?
General
