EasyManuals Logo

Ametek UPLC-II User Manual

Ametek UPLC-II
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
Appendix E: Sequence Of Events (SOE)Listing
E
January 2016 Page E–1
Appendix E: Sequence of Events (SOE) Listing
Access Events
<User name> Logged off
<User name> Logged on
Front panel logoff
Front panel logon
User logged in
User logged out
Hardware Events
DC power down
DC power up
General alarm
General alarm reset
I/O board failed
I/O board restored
Main power supply failed
Main power supply restored
Main TX power low
Main TX power OK
Novram settings restored from flash memory of <Date>
Power amp failed
Power amp restored
Redundant power amp failed
Redundant power amp restored
Redundant power supply failed
Redundant power supply restored
Redundant TX power low
Redundant TX power OK
Battery Failure
Firmware Events
All UPLC™ settings initialized to default values
DSP checksum mismatch
Ethernet settings restored from flash memory
Ethernet settings restored from flash memory of <Date>
Ethernet settings set to default values
SOE file system repaired
Software Watchdog reset occurred (x)
Events cleared

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ametek UPLC-II and is the answer not in the manual?

Ametek UPLC-II Specifications

General IconGeneral
BrandAmetek
ModelUPLC-II
CategoryControl Unit
LanguageEnglish