ii
e recommend that you become acquainted with the information in this manual before ener-
gizing your UPLC-II™ system. Failure to do so may result in injury to personnel or damage to
the equipment, and may affect the equipment warranty. If you mount the carrier set in a cabinet,
it must be bolted to the floor or otherwise secured before you swing out the equipment, to pre-
vent the installation from tipping over.
You should not remove or insert printed circuit modules while the UPLC-II™ is energized.
Failure to observe this precaution can result in undesired tripping output and can cause com-
ponent damage.
AMETEK does not assume liability arising out of the application or use of any product or circuit
described herein. AMETEK reserves the right to make changes to any products herein to
improve reliability, function or design. Spec ifications and information herein are subject to
change without notice. All possible contingencies which may arise during installation, opera-
tion, or maintenance, and all details and variations of this equipment do not pur port to be cov-
ered by these instructions. If you desire further information regarding a particular in stallation,
operation, or maintenance of equipment, please contact your local Ametek representative.
Copyright © Ametek
ALL RIGHTS RESERVED
AMETEK does not convey any license under its patent rights nor the rights of others.
!
W
ESD Warning!
YOU MUST BE PROPERLY GROUNDED, TO PREVENT DAMAGE FROM
STATIC ELECTRICITY, BEFORE HANDLING ANY AND ALL MODULES OR
EQUIPMENT FROM AMETEK.
All semiconductor components can be damaged by the discharge of static electricity.
Be sure to observe all Electrostatic Discharge (ESD) precautions when handling
modules or individual components.
IMPORTANT
To Next Page
Loading...
Need help?
General