Instrument Notifications and Troubleshooting A-4 Informational Notifications
MS2090A UG PN: 10580-00444 Rev. U A-11
<Name of Setting> range adjusted to accommodate user change
In Toolbar, Not logged, Transient. The setting can be distance, time and frequency.
Self test Passed
In Toolbar, Logged, Transient
Self test Failed
In Toolbar, Logged, Transient
Software update files found on USB
In Toolbar, Not Logged, Transient
Sensor <model> is not supported
In Toolbar, Logged, Transient
Sensor does not support target power setting.
In Toolbar, Logged, Transient
Stopped saving sweeps after sweep complete
When the save on event triggers are disabled after end-of-sweep.
Stopped saving sweeps after limit crossing
When the save on event triggers are disabled after a limit fails.
Trigger delay updated to minimum allowable value for selected bandwidth and bit format
In Toolbar, Not Logged, Transient
Settings changed; clearing EMF results
In Toolbar, Not Logged, Transient
The selected mode is not yet available
When an unavailable mode is selected.
Transmission (Ext. Sensor) measurement requires supported USB sensor
In Toolbar, Not Logged, Persistent
USB drive <name> ejected
In Toolbar, Not Logged, Transient
USB Power Sensor MA24xxxA detected
In Toolbar, Logged, Transient, xxx represents the model number of the power sensor.
USB Power Sensor MA24xxxA disconnected
In Toolbar, Logged, Transient, xxx represents the model number of the power sensor.
To Next Page
Loading...
