Instrument Notifications and Troubleshooting A-6 Error Notifications
MS2090A UG PN: 10580-00444 Rev. U A-17
A-6 Error Notifications
Antenna disconnected. Terminating measurement
In Toolbar, Logged, Transient
ALC Unlevel Error (X) @ Y Hz
In Toolbar, Logged, Transient. X represents the ALC that failed and Y represents the specific frequency
value at which the failure occurred.
Attempt to reboot instrument into Recovery mode failed
In Toolbar, Logged, Transient
Cannot start measurement without a connected Antenna
In Toolbar, Logged, Transient
Cannot set auto RBW ON due to exceeding IF bandwidth. RBW set to IF bandwidth
In Toolbar, Not Logged, Transient
Command Error
In Toolbar, Logged, Persistent
Could not lock to internal reference
In Toolbar, Logged, Persistent
Could not lock to external reference - check connection and try again
In Toolbar, Logged, Transient
Failed to connect to hardware
Persistent. When the connection to the hardware (server) could not be established.
Failed to recall limit
When the limit setup file selected for recall could not be accessed.
Failed to save file: filepath/filename
When any other error occurred while trying to save a file or when the connection to the hardware
(server) is broken.
Failed to save screenshot. Device may be full.
When saving a screenshot fails.
HW communication problem: SPA app unloaded
In Toolbar, Logged, Persistent
IQ capture complete. File saved
In Toolbar, Logged, Transient
To Next Page
Loading...
