Instrument Notifications and Troubleshooting A-5 Warning Notifications
MS2090A UG PN: 10580-00444 Rev. U A-15
Setting change detected; unloading playback file
In Toolbar, Logged, Transient
Save failed. File size exceeds save limits. Adjust setup and try again
In Toolbar, Logged, Transient
Shutdown Battery Level Reached
Pop-up Window, Logged, Persistent: Requires User Intervention
Sent after a Battery Low warning. A shutdown will occur when the battery charge is or below 5%.
Shutdown Temperature Reached
Popup, Logged, Persistent
Simulated Test Signal data being displayed
In Toolbar, Logged, Persistent
Spectrogram view not available
In Toolbar, Logged, Transient
Segment gate length too short. Increase RBW or VBW setting for segments (X)
In Toolbar, Logged, Persistent. X indicates the incorrect segments.
Temperature High Warning
In Toolbar, Logged, Persistent
Triangulation line limit reached
In Toolbar, Logged, Transient
The selected mode is not yet available.
When an unavailable mode is selected.
The ALC Cal Data is incorrect for the attached microwave module
In Toolbar, Logged, Persistent
The following options will expire in less than 24 hours <Option Number>. Reboot required. The system will
reboot at X.
In Toolbar, Logged, Persistent. X denotes the date and time.
The following options have expired <Option Number>. Reboot required. The system will reboot at X
Popup, Logged, Transient. X denotes the date and time.
The following options have expired <Option Number>
In Toolbar, Logged, Transient
The following options have expired <Option Number>
Popup, Logged, Transient
To Next Page
Loading...
