Instrument Notifications and Troubleshooting A-6 Error Notifications
MS2090A UG PN: 10580-00444 Rev. U A-19
The selected custom mask is invalid
In Toolbar, Logged, Transient
Trace playback not available
In Toolbar, Logged, Transient
Trace recording not available
In Toolbar, Logged, Transient
Trace has not been copied to memory
In Toolbar, Logged, Transient
Unexpected software exception. Reboot required.
When the instrument software requires a reboot due to unknown error, Persistent
Options <value> are not valid. Running without any options
In Toolbar, Not Logged, Persistent. This error may occur after a firmware update. Indicates that invalid
option numbers were detected (<value> indicates the invalid option numbers).
Options listed <value> are not valid. Restored to previous options
In Toolbar, Not Logged, Transient. This error may occur when upgrading options from an options
upgrade file fails due to an invalid option configuration. The options will be restored to the previous
options numbers.
Failed to upgrade options. Restored to previous options #
In Toolbar, Not Logged, Transient. This error may occur when upgrading options from an options
upgrade file fails due to an unknown reason. The options will be restored to the previous options
numbers.
Zero Sensor Error, remove any RF input signal to the external sensor
In Toolbar, Logged, Transient
To Next Page
Loading...
