P25 Phase 2 Commands 11-13 [:SENSe] Subsystem
S412E PM PN: 10580-00319 Rev. N 11-41
[:SENSe]:DM:FORMat BS|MS
[:SENSe]:DM:FORMat?
Description: Sets the modulation type to Base Station (BS) or Mobile Station (MS).
Please note that setting the modulation type will restart the sweep.
Cmd Parameters: BS|MS
Query Parameters: NA
Range: BS|MS
Default Value: BS
Default Unit: NA
Example: To set the modulation type to MS:
:DM:FORMat MS
Front Panel Access: Setup, Mod Type
[:SENSe]:DM:PATTern 1031hz|SILence|VOICe|CTRLchan
[:SENSe]:DM:PATTern?
Description: Sets the receiver pattern type. Please note that setting the Rx Pattern
will restart the sweep.
Cmd Parameters: 1031hz|SILence|VOICe|CTRLchan
Query Parameters: NA
Range: 1031hz|SILence|VOICe|CTRLchan
Default Value: 1031hz
Default Unit: NA
Example: To set the modulation type to voice:
:DM:PATTern VOICe
Front Panel Access: Setup, Rx Pattern
[:SENSe]:DM:SQUelch <value>
[:SENSe]:DM:SQUelch?
Description: Sets the squelch power level. The squelch is only applied to the P25p2
Analyzer Summary window on the front panel and will blank out (--) all
summary measurements except for Received Pwr when the received
power level is lower than the squelch power setting.
FETCh:SIGAnalyzer?, READ:SIGAnalyzer?, and
MEASure:SIGAnalyzer? will always return all numerical values.
The query will be returned in the units (dBm, Watts, or Volts) selected
through the Rx Units button using the front panel or with the
command: UNIT:POWer:RX. If the Rx Units has been set to dBm, the
squelch setting is returned in dBm. If the unit is set to Watts, the
squelch setting is returned in fW. If the unit is set to Volts, the squelch
setting is returned in fV.
To Next Page
Loading...
