2.5 Connection for Measurement
2-13
2.5 Connection for Measurement
This section describes connection for measurement.
Be sure to perform connection when power is off. Do not input signals
exceeding the rating value when peripheral equipment is connected.
Shapes of all BNC and D-sub 25-pin (DVB-SPI) connectors are the same.
Therefore, be sure to check input/output connectors when connecting.
Not doing so may damage the inside of the MP8931A.
Refer to Appendix A “Specifications” for DVB-SPI connector pin
assignment.
Note that the MP8931A continues outputting signals according to
parameter settings while the power is on.
To Next Page
Loading...
