Anritsu MP8931A - Device Message; Device Messages; Outline; Supported IEEE488.2 Common Commands

Section 5 Remote Control
5-12
5.4 Device Message
5.4.1 Outline
Device messages are data transmitted/received between controller and
devices, and consist of program messages (output from controller to the
MP8931A) and response messages (input to controller from the
MP8931A). Program messages consist of program commands for setting
MP8931A parameters or specifying processing, and program queries for
querying parameters or measured results.
5.4.2 Supported IEEE488.2 common commands
IEEE488.2 common commands supported by the MP8931A are shown in
the table below.
Table 5.4.2-1 IEEE488.2 common command list
Mnemonic Full spelling IEEE488.2 standards
1 *CLS Clear Status Command Mandatory
2 *ESE Standard Event Status Enable Command Mandatory
3 *ESE? Standard Event Status Enable Query Mandatory
4 *ESR? Standard Event Status Register Query Mandatory
5 *IDN? Identification Status Query Mandatory
6 *OPC Operation Complete Command Mandatory
7 *OPC? Operation Complete Query Mandatory
8 *RST Reset Command Mandatory
9 *SRE Service Request Enable Command Mandatory
10 *SRE? Service Request Enable Query Mandatory
11 *STB? Read Status Byte Query Mandatory
12 *TRG Trigger Command Mandatory for T1
13 *TST? Self Test Query Mandatory
14 *WAI Wait to Continue Command Mandatory