Section 3 Screen Display
3-8
3.5.1 Menu configuration
Menu configuration is shown in the figure below. Menu with setting
items under its submenu is indicated by “ * ”.
Main menu
Pattern setting (Pattern)
Interface setting (Interface)
Error addition setting (Error)
uto Sync setting (Auto Sync)
Output On/Off setting (Output)
Monitoring On/Off setting (Monitor)
External clock input menu (EXT Clock*)
Measurement menu (Measure*)
Repetition setting (Repeat)
Continued to the next page.
Selection (Measure)
On/Off setting (EXT Clock)
Level setting (Level)
Termination resistor setting
(Termination)
Measurement value display
setting (Select)
Time setting (Time)
Number of counts setting
(Count)
Burst setting (Burst)
To Next Page
Loading...
