Anritsu MP8931A - Burst Function Setting

4.2 Setting Parameters
4-19
4.2.9 Burst function setting
Enable/disable the Burst function. The Burst function should be enabled
when using inputs other than consecutive inputs within a frequency range
from 1 kHz to 155 MHz.
Note that the signal loss detection time is 600 ms maximum when the
Burst function is enabled.
1 to 50 ms (Max)
Burst interval
Select “Burst” on the main menu screen to perform setting.
Burst
Enable
Disable
Enable
<Procedure>
1. When the Burst setting items are displayed, select whether to enable
the Burst function (Enable) or not (Disable) by using the
∧
and
∨
keys. Press [Enter] to finalize the setting and display the main
menu again.