Anritsu MP8931A - Section 4 Operation

Section 4 Operation
4-1
This section describes item functions and their operation procedures.
[ ] and
indicate panel keys.
4.1
Basic System Settings .................................................. 4-2
4.1.1 Initialization (Initialize) ...................................... 4-3
4.1.2 GPIB address setting (GPIB Address) ............. 4-3
4.1.3 RS-232C baud rate setting
(RS-232C Baud) ............................................... 4-4
4.1.4 RS-232C parity bit setting
(RS-232C Parity) .............................................. 4-4
4.1.5 Display Auto-Off control setting
(Display Off) ...................................................... 4-5
4.1.6 Display brightness setting
(Display Dimmer) .............................................. 4-5
4.1.7 Version information (Version) ........................... 4-6
4.2 Setting Parameters ....................................................... 4-7
4.2.1 Pattern setting (Pattern) ................................... 4-7
4.2.2 Interface setting (Interface) .............................. 4-8
4.2.3 Error addition setting (Error) ............................. 4-9
4.2.4 Auto Sync setting (Auto Sync) ........................ 4-10
4.2.5 Output On/Off setting (Output) ....................... 4-10
4.2.6 Monitoring On/Off setting (Monitor) ................ 4-11
4.2.7 External clock setting...................................... 4-12
4.2.8 Measurement menu setting ............................ 4-14
4.2.9 Burst function setting ...................................... 4-19
4.2.10 Output function of NRZ interface setting ........ 4-20
4.2.11 Input function of NRZ interface setting ........... 4-23
4.2.12 Function of DVB-SPI interface setting ............ 4-27
4.2.13 Function of DVB-ASI interface setting ............ 4-30