Host Application Objects 182 (258)
Command Details: End_Pause
Details
Command Code 11h
Valid for: Object
Description
This command is sent to the host application when the system wants to return the system from a pause mode
back to “Ready to operate” mode. In the response message the number of milliseconds to actualize the
switch is returned.
• Command Details
(none)
• Response Details
Field Contents Comments
Data[0] Time To Operate (low word, low byte) Time needed to switch to “Ready to operate”
Data[1] Time To Operate (low word, high byte)
Data[2] Time To Operate (high word, low byte)
Data[3] Time To Operate (high word, high byte)
If the application is unable to end the pause it shall return the error code in the table below.
# Error code Description
0x0D Invalid state Given the state of the device, it is currently not possible to end the pause
Anybus
®
CompactCom
™
40 PROFINET IRT Network Guide SCM-1202-023 EN 1.8
To Next Page
Loading...