This chapter shows how to install the switch. The 2930M switches come with an accessory kit that includes the
brackets for mounting the switch in a standard 19-inch telco rack or in an equipment cabinet. Also included are
rubber feet that can be attached so the switch can be securely positioned on a horizontal surface. The brackets
are designed to allow mounting the switch in a variety of locations and orientations. For other mounting options,
contact your local Hewlett Packard Enterprise authorized network reseller or Hewlett Packard Enterprise
representative.
Shipping the switch in a rack
If the switch is to be shipped in a rack, it can be mounted and shipped in a Hewlett Packard Enterprise Universal
Rack.
• This method uses the HPE X410 Universal Rack Mounting Kit (J9583A).
• For more information and rack mount documentation, visit http://www.hpe.com/networking/support and
enter J9583A for search information.
• To order the J9583A rack mounting kit, contact your Aruba sales representative.
Included parts
The 2930M switches have the following components shipped with them:
• Documentation kit
• Accessory kit (5300-0103) containing:
two mounting brackets
eight 8-mm M4 screws to attach the mounting brackets to the switch
four 5/8-inch number 12-24 screws to attach the switch to a rack
four rubber feet
NOTE: Console cables can be ordered separately, or as an accessory to your switch:
Aruba X2C2 RJ45 to DB9 Console Cable (JL448A)
A standard micro-USB (Aruba switches) or mini-USB (HPE FlexNetwork switches) cable can be
used to console into the switch. Only data-capable USB cables can be used as console cables.
USB charging-only cables will not work.
• Power cord, one of the following (included with power supply unit):
Aruba 2930M PoE Switches
North America 8121-0973 Australia 8121-0857
North America high line 8121-0941 Brazil 8121-1265
South Africa/India 8121-1483 Europe/South Korea 8120-5336
Table Continued
Chapter 3
Installing the switch
Chapter 3 Installing the switch 33
To Next Page
Loading...
