Table 22: Uplink port LED error indicators
Global Status
LED
Mode/status Uplink port status
Usr SPD PoE Module
status
Port status See diag Tip
Slow Flash
Orange
Off Off Off Slow Flash
Orange
Slow Flash
Orange
1
Solid Green Off Off Off Solid Green Slow Flash
Orange
2
Slow Flash
Orange
Off Off Off Slow Flash
Orange
Off 3
Slow Flash
Orange
Off Off Off Slow Flash
Orange
Slow Flash
Orange
4
Table 23: Diagnostic tips for uplink port errors
Tip Problem Solution
1 Newly inserted uplink port module does not match
the previous uplink port module type.
Execute flexible-module <A> remove
2 Inserting an unsupported transceiver. Check the transceiver against the switch peripheral
support list.
3 Inserting an unsupported uplink port module. Ensure that the uplink port module is genuine.
4 Uplink port module unable to boot up. Usually this
behavior is a self-test error.
See Replacing the uplink port module on page
66.
Proactive networking
The 2930M switches have built-in management capabilities that proactively help you manage your network, they
include:
• Finding and helping you fix the most common network error conditions (for example, faulty network cabling,
and nonstandard network topologies).
• Informing you of the problem with clear, easy-to-understand messages.
• Recommending network configuration changes to enhance the performance of your network.
The following interfaces provide tests, indicators, and an event log that can be used to monitor the switch and its
network connections:
• IMC, an SNMP-based network management tool that is included with your switch.
• A graphical web browser interface that you can use to manage your switch from a PC running a supported
web browser, for example Microsoft Internet Explorer and Firefox.
• A full-featured easy-to-use console interface that you can access by connecting a standard terminal or PC
running a terminal emulator to the switch console port using an Aruba X2C2 RJ45 to DB9 Console Cable
(JL448A) (sold separately). The console command-line interface is also accessible through a Telnet or SSH
connection.
78 Aruba 2930M Switches