Tip Problem Solution
5 The network port for which the LED is blinking has
experienced a self-test or initialization failure.
Try power cycling the switch. If the fault indication
reoccurs, the switch port may have failed. Call your
Hewlett Packard Enterprise authorized network
reseller.
If the port is a pluggable SFP/SFP+ unit, verify it is a
pluggable supported by the switch. An unsupported
pluggable will be identified with this fault condition.
Caution: Use only supported genuine Hewlett
Packard Enterprise transceivers with your switch.
To verify that the port has failed, try removing and
reinstalling the SFP/SFP+. You can do that without
having to power off the switch. If the port fault
indication reoccurs, you will have to replace the
SFP/SFP+ unit.
Table Continued
Chapter 6 Troubleshooting 71
To Next Page
Loading...
