EasyManuals Logo

ASCOM D81 User Manual

ASCOM D81
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
TD 92644EN
User Manual
Ascom d81 DECT Handset
15 Troubleshooting
105
18 June 2018 / Ver. K
Error or Warning Messages
Display shows Probable cause Action or comment
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The
handset beeps once a
minute (during max 30
minutes) with a low
tone followed by a
high tone (if enabled,
the vibrator also
follows the beeps).
The handset is out of coverage
or handset is defective.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
No flash driver was
found
Note: This display
message is only
shown in English.
Failed to read from flash Send the handset for service.
SERVICE NEEDED
Hardware error
Note: This display
message is only
shown in English.
There is a communication
problem between components in
the handset.
Restart the handset. If the
problem persists, send the
handset for service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only
shown in English.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
Send the handset for service.
SERVICE NEEDED
Parameters corrupt.
Note: This display
message is only
shown in English.
The handset is defective. Select reset option on the
middle soft key if available or
if no reset option is available
or fault does not resolve the
handset needs repair. Note:
Display message only shown
in English.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
PDM/Device Manager or do a
factory reset via PDM/Device
Manager.
Battery low, charge
now
The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not
respond, not available at the
moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM/Device
Manager.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number
via PDM/Device Manager.

Table of Contents

Other manuals for ASCOM D81

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ASCOM D81 and is the answer not in the manual?

ASCOM D81 Specifications

General IconGeneral
BrandASCOM
ModelD81
CategoryHandsets
LanguageEnglish

Related product manuals