ASCOM I62 - 3.4 AP Scanning

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
11
3 Select the Numbers tab and click "New". The New numbers window is opened.
4In the Device Type and Parameter version drop-down lists, select the device type and
the parameter version to use, respectively. Note: The device type and parameter
version must match the handsets to be used to apply the template.
5In the Prefix field, enter the numbers’ prefix (if needed).
6 Create a range of numbers by selecting the "Range" option. Enter the start call
number and the end call number in the fields, respectively. Click “OK”.
Note: The maximum range that can be added at a time are 100 numbers.
7 Apply the network settings template to the selected handsets. See 4.4.2 Apply a
Template to a Handset with a Number on page 14.
8 Apply the common settings template to the selected handsets. See 4.4.2 Apply a
Template to a Handset with a Number on page 14.
9Close the IMS2.
4.1.4 Create a Network Template with Initial Configuration in the WinPDM
In a factory delivered handset, the WLAN settings are not configured that is required to
access the IMS2. Using the WinPDM allows the handset to be primed with the WLAN
parameters and allows it to log in to the Device Manager in IMS2 for future management
over the air.
Create a template with the basic network settings and IP adress to IMS2. This template is
only used once for each handset since it must access the WLAN and then log on the Device
Manager. After log in, the settings in the handset are changed according to the templates in
the Device Manager in IMS2.
1Open the WinPDM.
2 Do one of the following:
• If a network template was created in the Device Manager in IMS2, export this
template and import it to WinPDM. See Appendix A for more information.
(Recommended)
• Create a template (see 4.4.1 Create a template on page 13) with the following
network parameters:
3 Put the handset in the DP1 cradle.
4 Run the template. See 4.4.3 Apply a Template to Handset without a Number on page
14.
5 Remove the handset when synchronisation is finished.
6 Enter the Number and the password
1
(if any) . Press "Login".
Settings that were stored for the handset in the Device Manager in IMS2 will now be
downloaded to the handset. This can, for example, be unique soft- or hotkeys that have
been prepared earlier. When the settings have been downloaded to the handset, it might be
restarted depending on the parameter changes.
- Network settings
1
(located under Network > Network A (B, C, or D)
1. All required system settings for the WLAN. For example SSID and Security mode.
- Unite settings
2
(located under Device > Unite)
2.IP adddress and password (if any) to IMS2.
Note: The parameters in this template should be identical to the parameters
in the network template created in the IMS2.
1.The password is only required if the "Password" parameter is set.