ASCOM I62 - Replacement of Handset with IMS2

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
22
• If you have both WinPDM and IMS2, and need to apply the network template to the
spare handset(s) to log on it later on, see 5.2.3 Replacement of the Handset with
WinPDM and IMS2.
• If you only have WinPDM, see 5.2.4 Replacement of Handset with WinPDM Only.
Data included in a replacement transfer
The following data is replaced during a replacement:
•User parameters
• Contacts (entered by the user)
Note that the following data is not replaced:
• Call list
• Messages
• Company phonebook
• Downloaded language
• Certificates
•Licenses
1
5.2.2 Replacement of Handset with IMS2
There are two different replacement procedures as follows:
• If the broken handset and the spare handset have the same device type and
functionality license, see Replace without Move Licenses in IMS2 .
• If the broken handset and the spare handset have not the same device type and/or
functionality license. The license must be moved to the spare handset, see Replace and
Move Licenses in IMS2 on page 23.
Replace without Move Licenses in IMS2
Both the broken handset and the spare handset must be of the same device type and have
same functionality license.
1 In both handsets, press *#34# in idle mode and select "License" to check that they
have same device type and licenses.
If the login screen is displayed in the spare handset, press "Info" and select "License".
2 If the broken handset is online in the Device Manager, switch off the handset to make
it offline.
3 Take a spare handset prepared with the network settings (including the IP-adress to
the IMS2).
4 Enter the Number and leave the password blank. Press "Login".
The spare handset is automatically updated from the IMS2 and might be restarted
depending on the changed settings. The last stored settings for the broken handset in the
IMS2 has been transfered to the spare handset.
1.A handset’s license(s) can be moved to an unlicensed handset (i62 Talker) if following the replacement instructions
in
Replace and Move Licenses in IMS2 on page 23.