ASCOM I62 - Replacement of Handset with Winpdm Only

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
25
8 Make sure that the spare handset is saved in the Device Manager (indicated by a
in the Saved column. If not, in the Numbers tab, right-click the spare handset and
select "Save".
9 Switch off the spare handset to make it offline.
10 Switch on the broken handset to make it online.
11 In the Device Manager, select the "Licenses" tab.
12 Right-click the broken handset and select "Move license...".
13 In the Move license window, select the i62 Talker that should receive the license.
Press "OK".
14 The broken handset restarts and has now become an i62 Talker. Switch off the
broken handset to make it offline in the Device Manager.
15 Switch on the spare handset to make it online in the Device Manager.
16 In the Device Manager, select the "Licenses" tab. Right-click the spare handset and
select "Refresh".
The spare handset is automatically updated from the IMS2 and restarted. The last stored
settings and licenses for the broken handset in the IMS2 has been transfered to the spare
handset.
5.2.4 Replacement of Handset with WinPDM Only
Replacement via WinPDM is used in small VoWiFi systems or when IMS2 is not available.
• If the broken handset and the spare handset have the same device type and
functionality license, see Replace without Move Licenses using WinPDM .
• If the broken handset and the spare handset have not the same device type and/or
functionality license. The license must be moved to the spare handset, see Replace and
Move Licenses using WinPDM.
Replace without Move Licenses using WinPDM
Both the broken handset and the spare handset must be of the same device type and have
same functionality license.
1 In both handset, press *#34# in idle mode and select "License" to check that they
have same device type and licenses.
Alternatively, if the spare handset has been factory reset, press "Info" and select
"License".
2 Put the broken handset in the DP1 cradle.
3Open the WinPDM.
4 Make sure that the handset is saved in the WinPDM. In the Numbers tab, a saved
handset has the symbol in the Saved column. If not, right-click the handset and
select "Save" in order to transfer the settings to the spare handset later on.
5 If the spare handset has been previously used, perform a factory reset, see 5.1.8
Perform a Factory reset on page 21.
6 Put the spare handset in the DP1 cradle.
7A Found Device Wizard window appears. Select "Associate with Number" and click
"Next >".
8 In the list, select the broken handset to be replaced with the spare handset. Click
"OK".