TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
26
The broken handset has been replaced and its settings have been transfered to the spare
handset.
Replace and Move Licenses using WinPDM
The broken handset and the spare handset do not have the same device type and/or have
the same functionality license.
In order to move the licenses to the spare handset, it must be an unlicensed i62 Talker. To
check that the handset is unlicensed, press *#34# in idle mode and select "License". Only
i62 Talker must be displayed here.
1 Put the broken handset in the DP1 cradle.
2Open the WinPDM.
3 Make sure that the broken handset is saved in the WinPDM. In the Numbers tab, a
saved handset has the symbol in the Saved column. If not, right-click the handset
and select "Save" in order to transfer the settings to the spare handset later on.
4 Put an unlicensed spare handset (i62 Talker) in the DP1 cradle.
5 Run the template with the basic network settings containing (see 4.4 Configure a
Handset with a Template on page 13):
• Network settings
1
(located under Network > Network A, B, C, or D)
• VoIP settings
2
(located under VOIP)
The handset might be restarted depending on parameter changes.
6 Put the broken handset in the DP1 cradle.
7 In the WinPDM, select the "Licenses" tab.
8 Right-click the broken handset and select "Move license...".
9In the Move license window, select the i62 Talker that should receive the license.
Press "OK". The broken handset restarts and has now become an i62 Talker.
10 Put the spare handset in the DP1 cradle.
11 In the WinPDM, select the "Licenses" tab. Right-click the spare handset and select
"Refresh".
The spare handset is restarted and the licenses for the broken handset in the
WinPDM has been transfered to the spare handset.
12 A Found Device Wizard window appears. Select "Associate with Number" and click
"Next >".
13 In the list, select the broken handset to be replaced with the spare handset. Click
"OK".
The spare handset might be restarted and the settings for the broken handset in the
WinPDM has been transfered to the spare handset.
5.3 Change number of a VoWiFi Handset
It is possible to change the number of a handset, but keep all other settings in the handset.
1 Open WinPDM or the Device Manager in IMS2.
2 Open the Numbers tab, and select the handset to be updated with a new number.
1.All required system settings for the WLAN. For example SSID and Security mode.
2.VoIP protocol, Gatekeeper IP address or SIP Proxy IP adress used to access the PBX.
To Next Page
Loading...
