ASCOM I62 - Apply a Template to a Handset with a Number; Apply a Template to Handset Without a Number; Save Handset Configuration as a Template

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
14
The parameters that are not part of the template will be left unchanged on the handset. The
parameter version of an installed handset is visible under the Numbers tab or the Devices
tab.
4Click "OK".
5 Select the checkbox of each parameter that you want to be part of this template and
enter the proper value.
6 Click "OK" to save the template.
4.4.2 Apply a Template to a Handset with a Number
1 Open the WinPDM or the Device Manager in the IMS2.
2In the Numbers tab, select the handset(s) you want to apply the template to.
Note: If several handsets shall be selected, they must be of the same device type and have
the same parameter version.
3 Make a right-click and select "Run template...".
Only templates with a parameters version matching the selected handsets will be shown.
Select the template you want to apply and click "OK".
The template is applied. The number of parameters in the template will affect the time it
takes to apply the template to the selected handsets.
When looking at a handset under the Numbers tab, the column "Last run template" will
show the name of the most recently applied template.
Tip: It is also possible to apply a template on several handsets of the same device type
simultaneously using the Baseline function, see Installation and Operation Manual, IMS2,
TD 92586GB. This function cannot be used to download certificates to the handsets.
4.4.3 Apply a Template to Handset without a Number
Note: This feature is only applicabIe for the WinPDM. However, in the Device Manager in
IMS2, it is possible to apply a template to a handset without a number using the Baseline
function. The Baseline function or a template cannot be used to download certificates to the
handsets. See Installation and Operation Manual, IMS2, TD 92586GB.
It is possible to apply a template to a handset without a number in the WinPDM.
1 Put the handset in the DP1 cradle.
2In the Found Device Wizard window, select the "Run template" option.
3 Click "Next >".
Only templates with a parameter version matching the selected handset will be shown.
4 Select the template that shall be applied and click "OK".
The template is applied. The number of parameters in the template will affect the time it
takes to apply the template to the selected handset.
4.4.4 Save Handset Configuration as a Template
It is possible to save all settings of a handset as template. Note that this does not include
contacts, certificates and other personal data. The template will only contain configuration
data.
This template can be used as a backup if you want to restore the configuration of the
handset at a later stage or as a template that can be applied to a number of handsets.