ASCOM I62 - Replacement of the Handset with Winpdm and IMS2

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
23
Replace and Move Licenses in IMS2
The broken handset and the spare handset do not have the same device type and/or have
the same functionality license.
In order to move the licenses to the spare handset, it must be an unlicensed i62 Talker. To
check that the handset is unlicensed, press *#34# in idle mode and select "License" . Only
i62 Talker must be displayed here.
1 Make sure that the broken handset is saved in the Device Manager (indicated by a
in the Saved column. If not, in the Numbers tab, right-click the broken handset
and select "Save".
2 Switch off the broken handset to make it offline in the Device Manager.
3 Take an unlicensed spare handset (i62 Talker) prepared with the network settings
(including the IP-adress to the IMS2).
4 Enter the number and leave the password blank. Press “Login”. The handset is now
online in the Device Manager.
5 Make sure that the spare handset is saved in the Device Manager (indicated by a
in the Saved column. If not, in the Numbers tab, right-click the spare handset and
select "Save".
6 Switch off the spare handset to make it offline in the Device Manager.
7 Switch on the broken handset to make it online in the Device Manager.
8 In the Device Manager, select the "Licenses" tab.
9 Right-click the broken handset and select "Move license...".
10 In the Move license window, select the i62 Talker that should receive the license.
Press "OK".
11 The broken handset restarts and has now become an i62 Talker. Switch off the
broken handset to make it offline in the Device Manager.
12 Switch on the spare handset to make it online in the Device Manager.
13 In the Device Manager, select the "Licenses" tab. Right-click the spare handset and
select "Refresh".
The spare handset is automatically updated from the IMS2 and restarted. The last stored
settings and licenses for the broken handset in the IMS2 has been transfered to the spare
handset.
5.2.3 Replacement of the Handset with WinPDM and IMS2
If the spare handset to be used must be factory reset or no network template has been
applied, a WinPDM is needed to apply the network template to the spare handset. When the
network template is added, the handset can log on to the Device Manager.
There are two different replacement procedures as follows:
• If the broken handset and the spare handset have the same device type and
functionality license, see Replace without Move Licenses using WinPDM and IMS2 .
• If the broken handset and the spare handset have not the same device type and/or
functionality license. The license must be moved to the spare handset, see Replace and
Move License using WinPDM and IMS2 on page 24.
Replace without Move Licenses using WinPDM and IMS2
Both the broken handset and the spare handset must be of the same device type and have
same functionality license.