ASCOM I62 - Page 29

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
24
1 In the handset, press *#34# in idle mode and select "License" to check that both
handsets have same device type and licenses.
2 Make sure that the broken handset is saved in the Device Manager (indicated by a
in the Saved column. If not, in the Numbers tab, right-click the broken handset
and select "Save".
3 Switch off the broken handset to make it offline.
If the spare handset is not prepared with the basic network settings, also perform the steps
4 - 7.
4Open the WinPDM.
5 Put the spare handset in the DP1 cradle.
6 Run the template with the basic network settings containing (see 4.4 Configure a
Handset with a Template on page 13):
• Network settings
1
(located under Network > Network A, B, C, or D)
• VoIP settings
2
(located under VOIP)
• Unite settings
3
(located under Device > Unite)
7 Remove the handset from the DP1 cradle. The handset might be restarted depending
on parameter changes.
8 Enter the number and the password
4
(if any). Press “Login”.
The spare handset is automatically updated from the IMS2 and might be restarted
depending on the parameter changes. The last stored settings for the broken handset in the
IMS2 has been transfered to the new handset.
Replace and Move License using WinPDM and IMS2
The broken handset and the spare handset do not have the same device type and/or have
the same functionality license.
In order to move the licenses to the spare handset, it must be an unlicensed i62 Talker. To
check that the handset is unlicensed, press *#34# in idle mode and select "License" . Only
i62 Talker must be displayed here.
1 Make sure that the broken handset is saved in the Device Manager (indicated by a
in the Saved column. If not, in the Numbers tab, right-click the broken handset
and select "Save".
2 Switch off the broken handset to make it offline.
3Open the WinPDM.
4 Put the unlicensed spare handset (i62 Talker) in the DP1 cradle.
5 Run the template with the basic network settings containing (see 4.4 Configure a
Handset with a Template on page 13):
• Network settings
1
(located under Network > Network A, B, C, or D)
• VoIP settings
2
(located under VOIP)
• Unite settings
3
(located under Device > Unite)
6 Remove the handset from the DP1 cradle. The handset is restarted.
7 Enter the number and the password
3
(if any). Press “Login”.
1. All required system settings for the WLAN. For example SSID and Security mode.
2.VoIP protocol, Gatekeeper IP address or SIP Proxy IP address used to access the PBX.
3.IP address and password (if any) to the IMS2.
4.The password is only required if the "Password" parameter is set.