TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
55
For more information about presence management, see Function Description, Ascom VoWiFi
System, TD 92314GB or User Manual i62 VoWiFi Handset, TD 92599GB.
1 Select Presence > Common.
2In the Presence Management system drop-down list, select presence management
system.
3 Select "Presence" and the presence management system selected in previous step.
4In the IP address field, enter the IP address to the presence management system.
5In the Listening port field, enter the port number the presence management system
shall listen to.
6In the user name field, enter the Enter the user name.
7In the password field, enter the password.
If the Presence function is configured, it will be visible under Call > Presence in the handset.
It is also possible to configure a shortcut in order to access the Presence menu, see 6.5.11
Shortcuts on page 40.
6.15 Location
Two types of location are supported, either a basic location solution that gives an
approximate location using Access Point (AP) location, or a personal security solution that
gives a more accurate location using a third-party Real-Time Location System (RTLS)
solution.
The following RTLS solutions are supported:
•Cisco RTLS Solution
In order to use the Cisco RTLS solution, a Cisco Mobility Services Engine must be used and
configurations in the handset are required.
•Ekahau RTLS Solution
In order to use the Ekahau RTLS solution, the handset must have the Ekahau license (see
5.1.7 Upgrade Handset Functionality using License on page 18) and also be configured.
Additionally information about AP location and RTLS location, see Function Description,
Location in Ascom VoWiFi System, TD 92607 GB.
6.15.1 Configure Handset for Cisco/Ekahau RTLS Solution
1 Select Location > Common.
2In the Location scanning drop-down list, select "Enable".
3In the Scanning interval
1
field, set the time between the scanning periods.
4In the Scans per scanning period
1
drop-down list, select how many scans that should
be performed during each scanning period.
If the Ekahau RTLS solution is used, also perform the steps 5 - 8.
5 Select Location > Ekahau.
6In the EKAHAU license drop-down list, select "Yes". Additional parameters are shown.
7In the IP address field, enter the IP address to the Ekahau location appliance.
8In the Listening port field, enter the port the location appliance is listening to.
1.Note that close scanning periods, and frequently scans per period, will shorten the battery time.
To Next Page
Loading...
